1.HYDRAULIC OPERATED STEEL TOP DOORS
Two (2) hydraulically operated bi-fold steel top doors with hex brake for rigidity. Doors are insulated with 2” of high temperature insulation in a double steel jacket. The doors have rain seal caps and flex plates to keep asphalt out of door hinges. Each door shall have a 1 1/2” bore with 13” stroke hydraulic cylinder with bypass and flow control valves. The controls for doors are at the front of the unit behind truck cab passenger side.
With 12 VDC in-cab door controls
2.SECONDARY AUGER MOTOR
A secondary, hydraulic, 13,000 in.lb. Torque, variable speed booster motor installed at rear of auger to assist in dispensing bad or stiff asphalt mix. This also eliminates shearing coupler keys and bolts in the auger shaft.
3.DUAL AUGER CONVEYOR SYSTEM
Two (2) each, 10’ Long by 6” diameter progressive screw conveyors, to reduce asphalt bridging has hard surfaced flights, welded continuously on 2” schedule 80 steel pipe and is ball bearing mounted. Conveyors are driven by two (2) each 13,000 in lbs of torque variable speed hydraulic motors fully synchronized with forward and reverse. Unit shall have a delivery chute with 120° of pivot. All bearings can be greased from ground level through feeder lines.
4.ASPHALT SPREADER DELIEVERY SYSTEM
The asphalt spreader is hydraulic powered, ball bearing mounted 160º pivot, mounted on the rear of the main hopper auger dispensing system. Has a 52”X6” flight auger with splitter value allowing separate speed control from hopper screw conveyor and spreader auger conveyor. The conveyor is fully enclosed with releasing agent auger cleaning ports for safety. This system eliminates asphalt build up on asphalt chutes and is only recommended for large and long utility cuts.
5. TRAILER MODEL WORK DECK
Work Deck and Catwalk w/ Safety Railing Front
Work Deck and Catwalk w/ Safety Railing Back Must have Extended Auger
6.EXTENDED TRAILER TONGUE
3.5 Feet extended trailer tongue. Standard Length is 4’10” from edge of trailer.
7.EXTENDED SCREW CONVEYOR
12” extension of screw conveyor and rear bearing mount bracket. Allows the asphalt to be dispensed an additional 12” from asphalt hopper.
8. COST TO HARD SURFACED SCREW CONVEYOR
Hard Surfaced Screw Conveyor has hard wired bead welded on flight of auger to enhance longevity.
9.STANLEY COMPACTOR PLATE
Model SFP1850 Equipped with 5.5 hp gasoline Honda Engine with auto oil alarm shut down. Operating
Weight 220#, centrifugal force 4000#, plate size is 20” x 23”, water tank and locking holding down brackets.
10.VIBRATORY COMPACTOR PLATE
A Wacker WP 1550AW Compactor equipped with a 5.5 hp gasoline Honda Engine with auto oil alarm shut down. Operating weight is 196#, centrifugal force 3375#, plate size 19.5 x 23”, a water tank and locking holding down brackets.
Dolly Attachment Part No. – 0162986
11.VIBRATORY ROLLER
The vibratory roller is a Bomag BW55 E with a 4 hp Honda Engine, operating weight of 351#, centrifugal force 2250# and single drum vibratory roller 22” wide, centrifugal clutch and water tank.
Doosan Infracore Model SX1704-595 LB Single Drum Vibratory Roller
12.HYDRAULIC REAR LIFT PLATFORM FOR COMPACTOR
A hydraulically operated lift platform for loading or unloading compactor plate. The platform has a safety latch in the up position, an in cab “platform down” indicator light with compactor holding down brackets and a pavement breaker mount. All controls for platform are at the rear of the unit.
Additional cost for platform mounted on driver’s side
With Pavement Breaker Mount
Rear Lift for 600 LB Roller
13.HYDRAULIC REAR LIFT FOR ROLLER
A hydraulically operated lift platform for loading or unloading Bomag vibratory roller. The platform has a safety latch in the up position, an in cab “platform down” indicator light with roller hold down brackets and a pavement breaker mount. All controls for platform are at the rear of the unit.
Please specify: Driver’s side mounted or Passenger side mounted.
With Pavement Breaker Mount:
With Auto Return
14.ELECTRIC HOIST
A 12 volt 1 1/3 hp electric hoist is available for loading or unloading the vibratory compactor plate.
15.PAVEMENT BREAKERS
Stanley Pavement Breaker, complete with quick couplers, asphalt cutter with lockable transporting bracket.
A. BR45 lb. Hydraulic Hammer
B. BR67 lb. Hydraulic Hammer
Tamper and detachable shank
16.HYDRAULIC TOOL LINE HOSE REEL
Shall be 3000 PSI with dual 25’ hydraulic tool lines. Reel is spring loaded auto-retractable.
Hydraulic Tool Line Hose Reel with Reel Cover
17.INSULATED TARP TOP COVER
The tarp is a double form fitted 2” insulated tarp with tie downs. The tarp material is capable of sustaining 500 degrees F.
18.DIESEL FUEL HOSE REEL
Hose reel for diesel fuel spray wand has 20’ of hose. Reel is spring loaded auto-retractable.
19.TACK OIL HOSE REEL
Hose reel for tack oil has 15’ of hose. Reel is spring loaded auto-retractable.
Dual Feed Hose Reel, Air and Tack
20.AIRLINE HOSE REEL
An airline hose reel with 20’ of hose. Reel is spring loaded auto-retractable.
21.HYDRAULIC AIR COMPRESSOR
A separate self contained 15, 25 or 35 CFM @ 125 PSI. 1200 RPM hydraulic driven air compressor with 60 PSI oil pump and cooling fan, used to blow out repair sight and other compressed air demands. Hydraulic and electric controls are located at right rear of unit. Air compressor comes with quick couplers, 20 foot air hose, 5 foot air blow gun with deadman control valve, 5 gallon air tank with cable assisted condensation drain and 150 psi relief valve.
19 Gallon Air Received Tank
15 CFM @ 125 PSI Compressor with 5 gallon air tank
25 CFM @ 125 PSI compressor with 5 gallon air tank
35 CFM @ 125 PSI Compressor with 5 Gallon air tank
80 PSI Protector Valve
22.DRIP PAN
An eight (8) gallon drip pan for waste oil combination, for flushing pump, spray wand and lines at the end of the work day, with necessary valve for draining.
23.WATER TANK
A frame mounted stainless steel ten (10) gallon tank with valve and hose. Water supply for asphalt compactor plate..
25 Gallon Plastic Water Tank Mounted on Spoils Bin with 65 PSI water pump and sprayer
45 Gallon Plastic Water Tank Mounted on Spoils Bin with 65 PSI water pump and sprayer
50 Gallon Plastic Water Tank Mounted on Spoils Bin with 65 PSI water pump and sprayer
**** 26, 45 & 50 gallon not available on hydraulic driven air compressor****
24.FRAME MOUNTED LP GAS BOTTLE
A frame mounted 35 gallon or 50 gallon capacity LP Gas Bottle with quick fill connector, 10 psi regulator and fuel sight gauge.
35 Gallon LP Gas Bottle
50 Gallon LP Gas Bottle
LP Gas Hose & Auto Retractable Reel w/ 20FT of Hose
20 LB 5 Gallon LP Bottle w/ rack and 200,000 BTU Hand Torch
25.HANDTORCH
750,000 BTU Hand torch Power Jet 8017, Storm Proof Pilot w/ Transport Bracket
26.FUEL
100 lb. (25 gallon) removable propane bottle complete with 10 PSI regulator valve.
27.10-LIGHT DIRECTIONAL ARROW BOARD
The arrow board is an Able 2 with arrow flashing left, right and warning bar. The board is mounted on the rear of the patch unit with in cab controls.
LED lights
28.14-LIGHT DIRECTIONAL ARROW BOARD
State D.O.T. Approved Wanco model WSBA-14 or model WSBAL-14 (L.E.D.) 14 seal beam arrow board with arrow flashing left, right and warning bar. The board is mounted on the rear of the patch unit with in cab controls.
Wanco Model WSBA-14:
Wanco Model WSBLA-14 L.E.D. Arrow Board:
Hydraulic 2 side Arrow Board with 20 LED lights
Hydraulic 2 side Arrow Board with Center Mount Strobe with 20 LED lights
Arrow Stick Superior Signal SY900 50-LED
Wanco 30” x 60” SY990 LED Arrow Board
29. 16-LIGHT DIRECTIONAL ARROW BOARD
State D.O.T. Approved Superior Signal model SRTA16. With 16 amber (L.E.D.) lights, 32 flash patterns, 8 patterns per function. Arrow flashing left, right, and warning bar.
The board is mounted on the rear of the patch unit with in cab controls.
30.STROBE LIGHT
A pedestal mounted Meteorlight model SY2000 LED amber, 80 double flashes per minute.
31. TRUCK LIGHTS REDTANGLE 6.5” OVAL TAIL LIGHTS
LED RED, CLEAR, AMBER, & STROBE tail lights
32.WORK LIGHTS
Three (3) each 5" LED Flood Work Lights; Two (2) Rear Mount & One (1) Mount to light up inside of Hopper and LED Light-in Control Panel.
33.ASPHALT EDGER
Edger is designed to repair deteriorated shoulders on roads and repair water cuts and long trenches. Screw conveyor assembly is ball bearing mounted, conveyor is driven by a hydraulic motor with forward and reverse capabilities. Edger is powered with PTO driven load sense hydraulic pump. Unit mounts to rear of patch unit with 4 bolts. Has separate asphalt chute. Hydraulic splitter valve allows separate control from hopper screw conveyor to side deliver screw conveyor. Screw conveyor is fully enclosed for safety.
34. SPARE TIRE
Spare Tire with rim and lockable mount
35.FIRE EXTINGUISHERS
ABC fire extinguisher mounted on patch unit with vehicle mounting bracket.
5 Lb. In-cab mounted extinguisher
10 Lb. External mounted extinguisher
20 Lb. External mounted extinguisher
36.HIGHWAY WARNING TRIANGLES
A Highway warning triangle kit consisting of three (3) reflective triangles in a storage case.
37.EXTRA TOOL BOX
A 12 gauge steel 19” x 24” x 30” with water proof locking door.
38.ASPHALT LUTE AND SHOVEL HOLDER
Spring loaded asphalt lute and shovel holder, mounted curb side of unit.
39. SHOVEL CLEANER HOLDER
12”X12”X14” 11Guage Steel w/ 1” Drain with Fold Down Lid, Holds 3 Shovels, and Rear Mounted.
40.REAR MOUNT THROTTLE CONTROL FOR MANUAL ENGINES
Throttle control mounted at the rear.
41.SHOVELING APRON
Apron is constructed of 3/16” steel with fixed or folding bottom, mounted on platform below asphalt dispenser.
Apron with fixed bottom:
Apron with hinged, folding bottom:
Extended Shoveling Apron w/ Hinged Folding Bottom
42.LIQUID ASPHALT OIL TANK BURNER ONLY REQUIRED W/ CUT BACK ROAD OIL
To enable units to work emulsion or asphalt cut back oils, tank is equipped with a dry radiant chamber with a 75,000 BTU LP gas retort tube burner regulated @ 10 psi, thermostat controlled, and 12 volt dc electronic igniter with safety shut-off on loss of flame or excessive temperature.
43.TRAFFIC CONE RACK
Set of two (2) frame mounted traffic cone racks with holding capacity of ten (10) 28” tall cones.
44.ASPHALT LUTE
36” wide aluminum asphalt lute with 7 ft. handle.
45.ASPHALT SAW
Stanley C025-541 hydraulic hand held cut off and asphalt saw.
46. WATER COOLER
Water Cooler and Rack – 3 gallon
Water Cooler and Rack – 5 gallon
47. BACKUP CAMERA
Backup Camera RVS-770613 – Kit1 Color w/ sound
Backup Camera RVS-770613 – Kit1 Color w/ sound and Mobile Mule 5500 Mobile DVR on-board
Recording with Two (2) 128 GB SD Cards (256 GB Total) with GPS Capabilities.
48. UNDERCOATING
3M brand Body Schutz 8864
49. CUSTOM OPTIONS AVAILABLE
50. CONSPICUITY TAPE
Conspicuity tape on sides and rear of unit
1. PHPM-50 TACK OIL
Biodegradable tack oil, heat range spraying temperature 45º F to 85º F, and can be stored in tank 6 to 8 months without oil separation.
PHPM-50// 275 Gallon Tote
2. BANANA SLIDE RELEASING AGENT
Biodegradable releasing agent that works like diesel.
Banana Slide 5 Gallon Bucket
Banana Slide 55 Gallon Drum
Banana Slide 275 Gallon Tote